Week 6: Soldering

An issue arose recently with the entry points of the servo motor. There was a lead of a wire that broke off inside the entry point of the servo wiring. The lead was incredibly difficult to remove, the wires were separated from the piece that kept them attached.

The lead was stuck in the black piece connecting the wires, which was later removed

The separated wires were later soldered using a soldering iron. The wires were soldered to the wires that would be connected to the Arduino. There were issues with the soldering iron because it was relatively old and could not properly connect the wires together at first. Now, the issue has been adverted and the circuit works properly.